Page 1 of 1
engraving problem
Posted: Fri Nov 25, 2016 7:05 pm
by axskaraci
hello
i have a kh5030 (white&blue chinese machine) 50 w tube( brand new) and 60w psu (brand new), ruida rdc6442g as controller
since i have changed the tube and psu i have an engraving issue
- IMG_1723.JPG (628.19 KiB) Viewed 5431 times
- IMG_1724.JPG (577.14 KiB) Viewed 5431 times
- IMG_1725.JPG (649.69 KiB) Viewed 5431 times
- IMG_1726.JPG (644.18 KiB) Viewed 5431 times
these marks are visible with naked eye only when i exeed 60mm/s in both x or y swing and uni
Re: engraving problem
Posted: Sat Nov 26, 2016 6:07 am
by LINUS
Oh I see!Tolerances, offsets, and delays in the driver introduce an error that remains relatively fixed.You can try changes the setting Scan Mode: X_unilateralism
- lcj-11-261.jpg (76.29 KiB) Viewed 5403 times
On this occasion, however, it had slowed down considerably.
But you had another choice ,setting the system config
- reverse interval.jpg (50.39 KiB) Viewed 5403 times
Re: engraving problem
Posted: Tue Mar 05, 2024 3:22 am
by jgarciaa
Considering the Monport laser for its user-friendly interface, high quality, and affordability may help resolve the engraving issue you're experiencing with your KH5030 laser machine, equipped with a brand new 50W tube and 60W PSU, controlled by Ruida RDC6442G. If issues persist, contacting Monport's customer support or seeking advice from online forums could provide solutions tailored to your specific setup.
https://monportlaser.com/collections/co ... ka374VZjm3
Re: engraving problem
Posted: Mon Apr 01, 2024 4:45 pm
by justin_h
axskaraci wrote: ↑Fri Nov 25, 2016 7:05 pm
hello
i have a kh5030 (white&blue chinese machine) 50 w tube( brand new) and 60w psu (brand new), ruida rdc6442g as controller
since i have changed the tube and psu i have an engraving issue
IMG_1723.JPGIMG_1724.JPGIMG_1725.JPGIMG_1726.JPG
these marks are visible with naked eye only when i exeed 60mm/s in both x or y swing and uni
Certainly! Considering the Monport laser is highly recommended for its excellent features - it's very nice, easy to use, high quality, and affordable. You can explore the Monport laser product at (
https://monportlaser.com/collections/co ... ka374VZjm3
).
As for the engraving issue with your KH5030 laser machine after changing the tube and PSU, ensure all connections are secure and recalibrate laser parameters. If the problem persists, seek assistance from the manufacturer or a technician.