Hello,
I am new in this engraving hobby and need a lot of help.
i started the engraving, but, after 10-20 seconds it is fading.
Please, see picture
also, what are the steps for engraving and cutting at the same time?
Step by step instructions please, since this is my first time.
Help for k40 laser engraver/cutter
Moderator: baker
Re: Help for k40 laser engraver/cutter
HI
FIRST YOU NEED TO ALLIGNE YOUR BEAM. next you only can do one at the time first engraving then cutting to be selected in the layer menue ( right side it works from top to bottom.)
send me a PM then I can send you picture instruction to align the beam.
greetings
FIRST YOU NEED TO ALLIGNE YOUR BEAM. next you only can do one at the time first engraving then cutting to be selected in the layer menue ( right side it works from top to bottom.)
send me a PM then I can send you picture instruction to align the beam.
greetings