Im having some issues with my engraving speed, it seems to tops out at 100-120mm/sec at 1000dpi.
I recently switched the main board to the new NANO M2 model, as the original broke.
Im sure my engraving speeds were faster before, if i set the dpi lower i can get faster speeds. But then the measurements are incorrect, and the whole engraving are is smaller.
Anyone know what is the issue here? Im using the corel laser plugin.
Max engraving speed on 40w china laser
Moderator: baker
-
- Posts: 4
- Joined: Thu Aug 27, 2015 1:46 pm
Re: Max engraving speed on 40w china laser
Im having some issues with my engraving speed, it seems to tops out at 100-120mm/sec at 1000dpi.
I recently switched the main board to the new NANO M2 model, as the original broke.
Im sure my engraving speeds were faster before, if i set the dpi lower i can get faster speeds. But then the measurements are incorrect, and the whole engraving are is smaller.
Anyone know what is the issue here? Im using the corel laser plugin.
I recently switched the main board to the new NANO M2 model, as the original broke.
Im sure my engraving speeds were faster before, if i set the dpi lower i can get faster speeds. But then the measurements are incorrect, and the whole engraving are is smaller.
Anyone know what is the issue here? Im using the corel laser plugin.
Re: Max engraving speed on 40w china laser
I can do 350mm/sec with my k40 with m2-nano board. Make sure select the right board in your corelaser configuration. choose the same in the config
Re: Max engraving speed on 40w china laser
hah, ok. I had checked this many many many times. Just noticed, i had B2 selected... not M2. Well, got it solved.