Problem with accurate cutting Redsail 60 watt 500 x 700 bed
Posted: Sun Oct 23, 2016 12:18 pm
Hi there,
Looking for some help with my redsail 60watt laser cutter.
I am using auto laser 2.2.5 software to create files.
Using it to cut 3mm timber veneer but having a problem with the cutting and burning lining up with the file I have created. I have set the origin to be in the top left corner when standing at the machine as I have read it is best to make the origin as close to the laser source otherwise the laser needs to work harder.
Finding that once the machine has completed the burning component of the file it is meant to go back to the origin and complete the cutting BUT these do not match the file we have created. It always ends up about 3-4mm off. Very frustrating.
Have tried moving the origin, which did nothing.
I have attached some photos to explain what I mean.
Any suggestions greatly appreciated.
Looking for some help with my redsail 60watt laser cutter.
I am using auto laser 2.2.5 software to create files.
Using it to cut 3mm timber veneer but having a problem with the cutting and burning lining up with the file I have created. I have set the origin to be in the top left corner when standing at the machine as I have read it is best to make the origin as close to the laser source otherwise the laser needs to work harder.
Finding that once the machine has completed the burning component of the file it is meant to go back to the origin and complete the cutting BUT these do not match the file we have created. It always ends up about 3-4mm off. Very frustrating.
Have tried moving the origin, which did nothing.
I have attached some photos to explain what I mean.
Any suggestions greatly appreciated.