Hi guys,
I have had my ~ $800 chinese laser cutter with moshi bought on ebay for about a year.
recently i have noticed that the cuts are not clean.
Please take a look at the attached file (the material is printer paper):
1. the circle has a little bump in it
2. the square is not a square (3 sides are perpendicular but the right one is not)
Both shapes are around 1/2 inch in dimension
Any advice where to start troubleshooting it ?
I am trying to come up with a hypothesis - what could cause such a weird and repeatable deviation ?
any ideas would be very much appreciated,
Regards,
Lenny
Chinese laser cutter issue
Moderator: baker