Basic knowledge - Acrylic
Posted: Sun Mar 10, 2024 2:57 pm
Good evening. I am new to laser engraving and wanted to reach out to the community here for help on how to engrave/cut acrylic.
I recently purchased a WeCreat Vision which has a 20w laser and have had several challenges when it has come to engraving and cutting acrylic. Sometimes the laser burns right through and other times there is not even a mark made.
Attached a picture of a butterfly I tried to cut out but was unsuccessful.
Any support or guidance would be greatly appreciated.
Thank you
I recently purchased a WeCreat Vision which has a 20w laser and have had several challenges when it has come to engraving and cutting acrylic. Sometimes the laser burns right through and other times there is not even a mark made.
Attached a picture of a butterfly I tried to cut out but was unsuccessful.
Any support or guidance would be greatly appreciated.
Thank you