xTool D1 10W Diode laser - extra/overrun lines using Laserbox
Posted: Wed Jul 13, 2022 4:09 pm
I have been tasked with laser engraving items at my work for TM Recognition and other types of special gift events. Since then i have been having some success however some repairs are needed as there are in some instances severe issues causing scrap materials. I have searched many different paths to find out what could be happening or what settings might need adjusted however wanted to try my luck here to see if anyone could help point me in the right direction.
See the picture attached of what is happening; Only the LH Side of the images being etched is having these extra (entire vertical) or overrun small lines and am needing some help to try to fix this. Please share any ideas that you might have. Thanks in advance for any help.
See the picture attached of what is happening; Only the LH Side of the images being etched is having these extra (entire vertical) or overrun small lines and am needing some help to try to fix this. Please share any ideas that you might have. Thanks in advance for any help.