There is a problem with EzCad2 Version 2.14.10.
Under the Advanced button, there is a checkbox - Enable Fixed Width. This box doesn’t function as intended.
When checked, the program doesn’t fix the width of the object, but rather the position.
The object moves away from its normal position, but it should not.
EzCad2.14.10 position error
Moderator: baker
-
- Posts: 81
- Joined: Wed Aug 22, 2018 2:56 am
- Contact:
Re: EzCad2.14.10 position error
Hi, when you change some date in your software, have you connect the machine? i mean is the control board.
Also maybe there is some unknown error of the software, you can ask your supplier give you a new one instuall again,
Maybe can solved this problem.
Best regards,
Zoe
Also maybe there is some unknown error of the software, you can ask your supplier give you a new one instuall again,
Maybe can solved this problem.
Best regards,
Zoe