RDWorks Acceleration Values

[diggerdg]

I just setup my Chinese 50W CO2 laser (blue one on eBay) which uses RDWorks software for control. Test circles are coming out slightly oval. From other posts with similar problem, it recommended checking values of min/max acceleration to check if set too high. I am new to the metric system and have no idea what is correct. Current settings (unchanged from software install) are min acc (mm/2s) at 400 and max at 3000. Can someone provide some direction as to proper values?

[Thunder Laser -Nolan]

I think you question is wrong size machine cut
http://www.thunderlaser.com/troubleshoo ... -size.html
In our Thunder laser machine Current settings at 3000 to 10000

[diggerdg]

Thanks, was unaware that software had this feature. However still have problem. I do not know password or were to find it. When I it "OK" I get a "Password Error" message and can not continue. Tried "Password Settings" under Config and got error message "Communication Error". How do I find the Vendor password to use?

Additional Info: Have tried several trail and error things to try to determine the vendor password without success. Did find that had to have PC connected to laser to eliminate the "Communication Error" message. Under the "Password Settings" Config dropdown now get window that has a box for entering password that says Unlock Key, however it does not give a key. Software does appear to run machine but still can not get into the Vendor section to modify the stepper values.

[Thunder Laser -Nolan]

You need Consulting password from vendor.

[diggerdg]

Password obtained, followed solution link, and problem resolved.
Thanks

[harry56]

Thank you for your reply. I did not understand message please resend.



บาคาร่า

[Kalisahaf]

I know how to pull out a joint displacement as a varible Nodedisp. But is there any way to pull out joint velocity and acceleration values as varibles? I appreciate your answeres?

Sincerely,


Walter