Is it possible for the software to create a dotted or dashed line from an imported DXF line that is solid and is used for cutting? I can't quite understand what the DOT function is doing in the manual, but it appears to be for scanning.
What I'd like is to import a DXF line drawing, and then have the laser cut that line using (for example) 2mm on, 2mm off. This would create perforation effect.
Thanks
Dashed or Dotted Line
Moderators: baker, Thunder laser - Tom, Thunder Laser -Nolan
Forum rules
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
Re: Dashed or Dotted Line
I understand this now. the dot mode will indeed allow the creation of perforated lines.