How can I turn on the fan/blower and air compressor?
When I turn on the Mars130 laser no power is sent to the fan/blower and air compressor.
Thank You.
Turn on fan/blower and air compressor?
Moderators: baker, Thunder laser - Tom, Thunder Laser -Nolan
Forum rules
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
- Jasper_Rullman
- Posts: 11
- Joined: Fri May 15, 2015 2:48 am
-
- Posts: 115
- Joined: Fri Jun 05, 2015 8:16 am
Re: Turn on fan/blower and air compressor?
Hi Jasper
This is Tom from thunder laser
When you press start a job, the laser will turn on the fan and air compressor immediately
The laser send a work signal to a mainboard(TL-Timer) to asking output power to exhaust fan and air compressor
And when the job is finished, both device will be stopped after 5 seconds delay(for air compressor) and 15 seconds delay(for exhaust fan)
Their delay time can be change by a little mainboard that called TL-Timer are made by Thunder laser
Please try to send a file and start the job to see if they are work then
Have a good night
Best Regards
Tom
This is Tom from thunder laser
When you press start a job, the laser will turn on the fan and air compressor immediately
The laser send a work signal to a mainboard(TL-Timer) to asking output power to exhaust fan and air compressor
And when the job is finished, both device will be stopped after 5 seconds delay(for air compressor) and 15 seconds delay(for exhaust fan)
Their delay time can be change by a little mainboard that called TL-Timer are made by Thunder laser
Please try to send a file and start the job to see if they are work then
Have a good night
Best Regards
Tom
- Jasper_Rullman
- Posts: 11
- Joined: Fri May 15, 2015 2:48 am
Re: Turn on fan/blower and air compressor?
I just solved it.Thunder laser - Tom wrote:Hi Jasper
This is Tom from thunder laser
When you press start a job, the laser will turn on the fan and air compressor immediately
The laser send a work signal to a mainboard(TL-Timer) to asking output power to exhaust fan and air compressor
And when the job is finished, both device will be stopped after 5 seconds delay(for air compressor) and 15 seconds delay(for exhaust fan)
Their delay time can be change by a little mainboard that called TL-Timer are made by Thunder laser
Please try to send a file and start the job to see if they are work then
Have a good night
Best Regards
Tom
Thanks!
All the Best,
Khristian Bombeck
-
- Posts: 115
- Joined: Fri Jun 05, 2015 8:16 am
Re: Turn on fan/blower and air compressor?
Hi Khristian
Good job
Any unclear, please contact with us again
Have a nice dream
Best Regards
Tom
Good job
Any unclear, please contact with us again
Have a nice dream
Best Regards
Tom