Scan/Engrave Direction
Moderators: baker, Thunder laser - Tom, Thunder Laser -Nolan
Forum rules
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
Scan/Engrave Direction
Hello, I am looking for a way to change my scan/engrave direction to- bottom to top (for example, if it was an image of a person, I would want to start engraving at the feet and work my way up to the head). I am not sure if this is done in RDWorks or via the machine. Thank you.
Re: Scan/Engrave Direction
Hi Rayden,
It can be done by rdworks.
From menu bar,config>>system setting.
It can be done by rdworks.
From menu bar,config>>system setting.