Hello Everyone!
I'm new to this and just received a laser yesterday (Boss LS-1416 60w). After about a day of setup and arranging things, exhaust system, etc. I finally went to engrave my 1st test piece. Turns out the main laser will not fire. The company forgot to send me the loopback plug for the Chiller Signal outlet port. So I'm dead in the water until Monday, plus shipping time for them to hopefully send me one out.
Does anyone have a Boss LS-1416 system that can tell me which pins are shorted on the loopback. I'm sure I could make my own real quick if I knew. Its a 4-pin outlet. See page 5 for what I'm talking about. Its just a plug with a wire connecting two pins (I assume).
https://bosslaser.com/Download_pdf/B...tall_Guide.pdf
If anyone can help me out I would greatly appreciate it! I'm going nuts with this great equipment in front of me that I cannot use!
Newbie! I need help.Boss Laser LS-1416 Chiller Signal outlet pinout
Moderator: baker
Re: Newbie! I need help.Boss Laser LS-1416 Chiller Signal outlet pinout
Did you try asking Boss Laser for this info?