Hi
I own a Thunderlaser mini 60 which I use to manufacture model railway kits I've had some issues over the last 24 hours with engraving. When I save the UD file Lasergrav gives a warning 'Engraving Layer contains a non closed graphic which are not carving'
It then won't engrave the detailed walls of my cut, although previously it hasn't been a problem.
Does anyone know the answer to this?
Many thanks
Andy
Lasergrav error---20160222
Moderators: baker, Thunder laser - Tom, Thunder Laser -Nolan
Forum rules
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
-
- Posts: 84
- Joined: Fri Jun 05, 2015 8:18 am
Re: Lasergrav error---20160222
Please wait for a moment while service engineer is to solve the problem for you.
-
- Posts: 115
- Joined: Fri Jun 05, 2015 8:16 am
Re: Lasergrav error---20160222
Hi Andy
Sorry to reply so lately
If your laser software is used LaserGrav?
If yeah, please send your file to this email: tech@thunderlaser.com
I will try to check and fix it for you later
Thanks in advance
Sorry to reply so lately
If your laser software is used LaserGrav?
If yeah, please send your file to this email: tech@thunderlaser.com
I will try to check and fix it for you later
Thanks in advance