Laser Engraver Forum

Hi,

I'm new user Mike. I've been using a CO2 laser since 2002 and have created a tips and techniques document on what I've found (and wish I knew before). I'd like to share it. It's really a work-in-progress. I work at Microsoft Research Hardware Lab where our two lasers get more use than a screwdriver.

Here's the document It describes methods for precision bending thermal plastic, welding, creating smooth beveled edges and much more.

Hope you find it useful.

Hey, these services provided by the experts of this website are good. But if you are looking for a Documents converter then you can visit this site and use the service available on this website for these services. I am sure you will get your work done easily.