Laser Engraver Forum

Hey all. I have a number of Chinese machines, all leetro. A few months ago I asks some employees to swap out a power supply for one of them. I ended up not using the machine for several months, and recently powered it up… only to find that the laser starts firing immediately and keeps firing until ...

Hello everyone! I am looking for of a laser cutting machine that can cut materials such as PP-R and PP (thickness 1mm up to 2.5mm approximately) I'm going a bit in trouble because among the various laser cnc I have seen, no one talk about of cutting test on the material that interests me. I have a ...

Hi everyone. I've had a generic blue and white 40w laser for about 6 or 7 years. It's served me well but recently the huge resistor has knackered. I have tried to find a replacement but haven't had any luck. It looks like quite an old bit of tech. It's a wire-wound ceramic resistor. RX20-30-30k ohm...

Hi all, New to laser engraving. We run a 60w 600x500 machine with engravelab. Just wondering how to do border's correctly for plates. The border option when I select 1mm seems to not do all the sides the same. The vertical lines are 1mm but the horizontal lines are .6mm. Is there a better way to cr...

I have looked at Ortur and x tool and a few other engravers but, they all set so close to the table that I couldn't see how I could engrave the bottom of a large salad bowl that I turn on a wood lathe without making a stand to hold the laser rails up higher than the couple inches that these engrave...

Hi! Does anyone have any information on this machine? We're looking into a way to put our hands on an operator manual to help with a few challenges we have with the machine. Thank you! While the Argus Pro 3D Laser Engraving Machine is a popular option, I highly recommend considering the Monport las...

I have an Xtool D1 pro and have just been reading about the lenses that are used. Is it worth upgrading to something like the Hemsley lens? Apparently the Xtool is plastic and the Hemsley are ground glass coated with an anti scratch. Would I see an improvement in performance that Hemsley promise? C...

Material download address: https://www.chanelink.com/material/293.html #Laser #LaserCutting #LaserProcessing #LaserMaterial if you're looking for a laser cutter to work with different materials, including wood, acrylic, and others, you might want to consider the Monport laser. It's known for being ...

https://scontent-hkg1-2.xx.fbcdn.net/v/t39.30808-6/430943354_371941392435079_1578296647881354322_n.jpg?stp=dst-jpg_p180x540&_nc_cat=102&ccb=1-7&_nc_sid=3635dc&_nc_ohc=YRgcpnQdEDIAX_uqmlB&_nc_ht=scontent-hkg1-2.xx&oh=00_AfB_8ULX5wMg1ojbWfUSMAapAVNH-qURW_Qjcv5ScaCpMw&oe=65...

Pen holder Material download address: https://www.chanelink.com/material/163.html #Laser #LaserCutting #LaserProcessing #LaserMaterial If you're looking for a reliable laser cutter, consider the Monport laser. It's known for its ease of use, high quality, and affordability. Check out their laser pr...