Search found 6 matches
- Mon Oct 31, 2022 6:53 pm
- Forum: General Laser machine discussion
- Topic: How to adjust for height?
- Replies: 5
- Views: 3753
Re: How to adjust for height?
If the focus is fixed, the distance between the laser module and the surface of the part is always the same (usually a few mm)... if the focus is adjustable, you can move the module away and then adjust the focus, which is convenient for great height.
- Mon Oct 31, 2022 6:47 pm
- Forum: General Laser machine discussion
- Topic: Horizontal vs vertical lines. Is this normal?
- Replies: 2
- Views: 2313
Re: Horizontal vs vertical lines. Is this normal?
You are out of focus. Adjust it correctly by doing a ramp test.
https://www.youtube.com/watch?v=2hXCuVSvuJo
https://www.youtube.com/watch?v=2hXCuVSvuJo
- Sat Jun 04, 2022 5:55 pm
- Forum: General Laser machine discussion
- Topic: Getting a small focus point
- Replies: 1
- Views: 1394
- Sat Jun 04, 2022 5:49 pm
- Forum: General Laser machine discussion
- Topic: Laser won't turn off
- Replies: 2
- Views: 1239
Re: Laser won't turn off
2-pin laser does not have PWM. If your board has a Motor input you must connect it to this. If you connect it to the 12v input, it will always be on and without control. What inputs does your board have? Have a picture?
- Fri Nov 26, 2021 12:07 am
- Forum: General Laser machine discussion
- Topic: What type of machine do I need?
- Replies: 2
- Views: 3689
- Fri Nov 26, 2021 12:01 am
- Forum: General Laser machine discussion
- Topic: Cheap Chinese Laser Engraver
- Replies: 5
- Views: 3333
Re: Cheap Chinese Laser Engraver
Benbox is very limited software, would recommend
to you the LaserGRBL, free and very complete software... and they have their own forum for help.
to you the LaserGRBL, free and very complete software... and they have their own forum for help.