Questions
Posted: Fri May 06, 2016 8:09 am
Hello!
Nobody replied. So, I wrote the same post here.
You can check the photo through my last post.
I have three questions.
1. When we cut the Acrylic sheet, it seems something sticking out of edge. So, the edge is too sharp.
And, when we touch the edge we feel rough.
I do not know I explain plainly or not. I am attaching the drawing to explain the edge.
The ruler you offered does not have sharp edge. It is smooth even though the edge is 90 degrees.
It seems that there is something on the edge.
2. When we try to align the mirrors.
We cannot make small hall. We always have small circle burning mark.
On your movie clip, you made a very small dot.
Could you tell me how to make small dot. I am attaching photo.
3. You had said to remove the level sensor to solve not moving Z axis problem.
I disconnected the sensor and then the problem solved.
Does it mean the sensor has the problem?
Can I keep using the machine without sensor?
Thanks in advance.
Nobody replied. So, I wrote the same post here.
You can check the photo through my last post.
I have three questions.
1. When we cut the Acrylic sheet, it seems something sticking out of edge. So, the edge is too sharp.
And, when we touch the edge we feel rough.
I do not know I explain plainly or not. I am attaching the drawing to explain the edge.
The ruler you offered does not have sharp edge. It is smooth even though the edge is 90 degrees.
It seems that there is something on the edge.
2. When we try to align the mirrors.
We cannot make small hall. We always have small circle burning mark.
On your movie clip, you made a very small dot.
Could you tell me how to make small dot. I am attaching photo.
3. You had said to remove the level sensor to solve not moving Z axis problem.
I disconnected the sensor and then the problem solved.
Does it mean the sensor has the problem?
Can I keep using the machine without sensor?
Thanks in advance.