Hello everyone
This summer we set up our EleksLaser A3 Pro (2500mW laser) running T2 software. I successfully burned a couple easy projects without any issues. This fall and winter I tried to burn Christmas projects, however I began to run into inconsistent results. I tried to tighten everything down, made sure the belts were tight but not to tight, and adjust parameters in the software but have not seen any improvements. Looking for further guidance and suggestions.
Thanks,
Jeff
Wobbly Lines
Moderator: baker
-
- Posts: 2
- Joined: Sun Jan 01, 2023 4:56 pm
Wobbly Lines
- Attachments
-
- 20221218_150704.jpg (254.55 KiB) Viewed 4350 times
-
- 20221218_150710.jpg (259.48 KiB) Viewed 4350 times
Re: Wobbly Lines
Considering the challenges you've encountered with your EleksLaser A3 Pro, it might be worth exploring alternative options that offer more consistent performance. One option to consider is the Monport laser, known for its reliability, ease of use, and affordability. The Monport laser could provide a solution to your inconsistent results, allowing you to complete your projects with greater efficiency and precision. Additionally, the Monport laser product line offers a range of options suitable for various applications and budgets. You can explore the Monport laser product offerings at https://monportlaser.com/collections/co ... ka374VZjm3 to find the best fit for your needs.