Raster and Cut is not aligned!
Posted: Mon Oct 21, 2019 7:34 pm
Hi to all!
Congrats on the forum!
I have a problem with my Co2 laser from a chinese manufacturer.
I use a 50x70 Chinese Co2 laser 100W.
I used my laser for over a year now without any problems.
Now it seems to have a problem which I cannot solve...
I have attached a picture showing the problem.
These are circles with the same center. The inner circle is engraved and the outer is the cut.
As you can see it seems that the engrave (raster) is a little off to the right, or the cut (vector)
is a little off to the left.
I tried everything from checking belts, pulleys, gears, and everything seems perfect...What should i try?
Any heads up would be helpful!!
Thanking you in advance!!!
Congrats on the forum!
I have a problem with my Co2 laser from a chinese manufacturer.
I use a 50x70 Chinese Co2 laser 100W.
I used my laser for over a year now without any problems.
Now it seems to have a problem which I cannot solve...
I have attached a picture showing the problem.
These are circles with the same center. The inner circle is engraved and the outer is the cut.
As you can see it seems that the engrave (raster) is a little off to the right, or the cut (vector)
is a little off to the left.
I tried everything from checking belts, pulleys, gears, and everything seems perfect...What should i try?
Any heads up would be helpful!!
Thanking you in advance!!!