Hi
I was running exactly the same file with:
standard laser head - focal distance 6mm
HR head - focal distance 4 mm
I was hoping to get even better results with HR head..... but I didn't.
What settings should I chnage?
Thank you
Anda
standard laser head vs HR head
Moderators: baker, Thunder laser - Tom, Thunder Laser -Nolan
Forum rules
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
- andaluzia1973
- Posts: 22
- Joined: Wed Jul 05, 2017 11:50 am
standard laser head vs HR head
- Attachments
-
- 35812678_10156075356438387_2931402521974931456_n.jpg (91.54 KiB) Viewed 15036 times
-
- 35887067_10156075356423387_9171004922248822784_n.jpg (148.73 KiB) Viewed 15036 times
Re: standard laser head vs HR head
Hi Anda,
I wonder if you use HR head to cut material.
Please noted,the HR head is generally used only for engraving,if you want to cut,you can only cut something very thin,like paper.
I wonder if you use HR head to cut material.
Please noted,the HR head is generally used only for engraving,if you want to cut,you can only cut something very thin,like paper.