Hello,
I have Nova24 - Laser System and the problem is with X-Axis -it does not work.
I checked the X-axis controller - the controller is switched on, the green LED is on and the red one blinks.
I installed the controller with Y-axis and there is still the same problem (green LED is on and the red one is blinks)
How to solve this problem?
I am looking forward to your soon response.
Mariusz
X-axis does not work
Moderators: baker, Thunder laser - Tom, Thunder Laser -Nolan
Forum rules
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
Re: X-axis does not work
Hi Mariusz,
Sorry for your problem.
About your problem,X-axis does not work,i'm wondering if the laser head can reset to top left corner when turn on the machine,or just Y axis work well.
Sorry for your problem.
About your problem,X-axis does not work,i'm wondering if the laser head can reset to top left corner when turn on the machine,or just Y axis work well.
Re: X-axis does not work
Hi Ben,
Laser head can reset to top left corner when turn on the machine and then there is an error on the driver -
green LED is on and the red one is blinks
Mariusz
Laser head can reset to top left corner when turn on the machine and then there is an error on the driver -
green LED is on and the red one is blinks
Mariusz
Re: X-axis does not work
Hi Mariusz,
OK,the laser hear can reset to top left corner,so the connection for motor and driver should be fine.
So if the laser head can normally touch the X axis limit switch,or hit the limit switch and stop then do not move anymore.
OK,the laser hear can reset to top left corner,so the connection for motor and driver should be fine.
So if the laser head can normally touch the X axis limit switch,or hit the limit switch and stop then do not move anymore.
Re: X-axis does not work
Check your datum position, on the LCD it should show the position of the X/Y when the machines is zeroed at datum, if it is not set correctly it will not show 0/0 as X and Y
Re: X-axis does not work
The machine is already in operation, the X-axis end limit switch cable was damaged
Thanks for the help
Mariusz
Thanks for the help
Mariusz