Page 1 of 1

Nova 63 - red dot pointer / xy axis/ water-oil separator

Posted: Mon Apr 23, 2018 7:18 am
by andaluzia1973
Hello Ben

I have identified at least 3 big problems with the machine.

#1. There is no red dot pointer, it has never worked. I have attached pic to see that I cannot see any red dot pointer on the material that I am trying to cut. (pic red_dot_pointer.jpg)

#2. The XY axis - the head does not go to the top left corner and goes beyond the low left corner (pic head_top_left.jpg and head_low_left.jeg)

#3. I did not receive the water-oil separator even if I have purchased the big air pump tank.

I would appreciate if you can point me how to fix these problems, I have some orders and I would like to be able to work with the machine.

Thank you.
Anda

Re: Nova 63 - red dot pointer / xy axis/ water-oil separator

Posted: Mon Apr 23, 2018 7:53 am
by Ben
Hi Anda,

Sorry for those problem.
#1. I think the alignment of red dot should have been changed during shipping.You will need to adjust it to make the red light coming out from the laser head.How to do it please refer to the picture below.
realign red dot.jpg
realign red dot.jpg (521.23 KiB) Viewed 4055 times
#2. The head goes beyond the low left corner,what do you mean about that,it would be good to show me some pictures.

#3. The water-oil separator won't came with the big air compressor,i will check your invoice with our sale person,i will let you know once confirmed.

Re: Nova 63 - red dot pointer / xy axis/ water-oil separator

Posted: Mon Apr 23, 2018 9:07 am
by andaluzia1973
Hi Ben.

Low left corner
Attached is the image that shows that the laser head goes beyond the low left corner of the flatbed. it goes to the metalic edge, does not stop where the honey comb ends.

Top left corner
On the other side, you can see on the second picture where are the burn marks on the honeycomb. It shows clearly that the laserhead did not go to the top left corner.

Thank you

Re: Nova 63 - red dot pointer / xy axis/ water-oil separator

Posted: Mon Apr 23, 2018 9:11 am
by andaluzia1973
the other pic

Re: Nova 63 - red dot pointer / xy axis/ water-oil separator

Posted: Mon Apr 23, 2018 9:51 am
by Ben
Hi Anda,

#2. Ok,i got it.
Actually,the laser head is working well on 1600*1000 mm working area.
But why the laser head will go beyond a little bit from the honeycomb table,because we fasten the honeycomb table on the machine with two Plug-pin,see below.
QQ图片20170622141942.jpg
QQ图片20170622141942.jpg (135.8 KiB) Viewed 4046 times
QQ图片20170622141938.jpg
QQ图片20170622141938.jpg (95.93 KiB) Viewed 4046 times
After that,the honeycomb table will a little bit close to top side.
The bed cannot be move to low side anymore installing on current machine body,we need to modify the machine body for the future machine to fix this problem.Please understand.
At present,you can loose the honeycomb table by removing this two plug-pin,then move it to low side.
And you can also take out the honeycomb table and use the Aluminum blade cutting table.
http://www.thunderlaser.com/features/al ... table.html
by the way,i'm sorry for this problem.

#3. For the water-oil separator,sorry again it's our mistake.
Please send me your current address and phone number via email.
My email address: Ben@thunderlaser.com