The image comes out all wrong when I'm trying to engrave on a glass.
The diameter on the glass is 81 mm. Please look at the pictures with my settings.
When I write 81 mm diameter the engraving is very compact. Look at Image 1.
Look also at image 4, where you see that the image is supposed to have 112 mm height. But when I push the preview it says 55,7 mm height. Look at image 5
What am I doing wrong?
Any help will be appreciated:)
Problems with setting for rotary axis
Moderators: baker, Thunder laser - Tom, Thunder Laser -Nolan
Forum rules
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
Problems with setting for rotary axis
- Attachments
-
- Image 4.jpg (95.86 KiB) Viewed 7541 times
-
- image 1.jpg (76.39 KiB) Viewed 7541 times
-
- 20180113_125010 1.jpg (73.96 KiB) Viewed 7541 times
-
- 20180113_125000.jpg (83.52 KiB) Viewed 7541 times
Re: Problems with setting for rotary axis
Hi Jon,
This is Ben from Thunderlaser.
About your problem,
1.the setting for software is alright. Select “Output”, and then tick“Enable rotate engrave”
① The Circle pulse is set to 16000 (Please set circle pulse to 7601 while your machine is bought before February 2016, Not including Feb 2016)
② The diameter of the target item
2.the setting for rotary attachment. Number 1-6:on off on off on off.
please check them and test again.
This is Ben from Thunderlaser.
About your problem,
1.the setting for software is alright. Select “Output”, and then tick“Enable rotate engrave”
① The Circle pulse is set to 16000 (Please set circle pulse to 7601 while your machine is bought before February 2016, Not including Feb 2016)
② The diameter of the target item
2.the setting for rotary attachment. Number 1-6:on off on off on off.
please check them and test again.
Re: Problems with setting for rotary axis
Hi!
I think that worked. Button number 3 was in wrong position for some reason. Thanks:)
I think that worked. Button number 3 was in wrong position for some reason. Thanks:)