Hello,
i am facing a problem with my laser cutting system:
A few weeks ago, i had a lot of smoke while cutting any substrate.
I noticed the problem was because the grid before the fan tube was dirty, and cleaning it solved my problem.
But now, i got the same problem, even if the grid is clean, the fan seems to work perfectly (i can even see smoke coming out of it outside the building), but i have more and more smoke in the machine and around it.
I even removed the fan tube to check inside, but everything seems ok.
I can notice that the problem is getting worse at each sheet, so i don't think it's a substrate problem...
Do you have any idea what i can do at this time please?
Thank you for your help...
SMOKE PROBLEM
Moderators: baker, Thunder laser - Tom, Thunder Laser -Nolan
Forum rules
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
Re: SMOKE PROBLEM
You need to take the fan apart and clean it, residu build up makes the fan inefficient...
I had the same problem a few weeks ago!
I had the same problem a few weeks ago!
Re: SMOKE PROBLEM
Thank you for your help: it's exactly the problem.
Now solved
Now solved