Hey Ben!
Thank you for your quick reply.
Here is a photo.
We cut a bear shape which is a symmetrical shape.
We cut it in a half. It means that two half of bear shape should be the same.
But, there are differences. the gap is 2~2.5mm.
We checked the level of the cutting board again. And, it is ok.
And, the bear shape cut in left part of cutting bed is symmetrical.
Not accurate cutting problem.
Moderators: baker, Thunder laser - Tom, Thunder Laser -Nolan
Forum rules
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
Re: Not accurate cutting problem.
- Attachments
-
- temp-test-02.jpg (518.88 KiB) Viewed 5744 times
Re: Not accurate cutting problem.
Hi Joon,
Thanks for your picture.
Okay, the gap is 0.2~0.25mm.
please create a circle by RDworks and cut it, if it is the same problem.
Thanks for your picture.
Okay, the gap is 0.2~0.25mm.
please create a circle by RDworks and cut it, if it is the same problem.
Re: Not accurate cutting problem.
Hey.
Thanks for your suggestion.
I was too busy to have a test.
So, I have just taken a test.
I drew the circle in Laser program you provided.
And cut the circle.
You might see the differences.
The difference is 1mm.
Is that a problem? If it is, do you have any suggestion to solve the problem?
Thanks in advance.
Joon
Thanks for your suggestion.
I was too busy to have a test.
So, I have just taken a test.
I drew the circle in Laser program you provided.
And cut the circle.
You might see the differences.
The difference is 1mm.
Is that a problem? If it is, do you have any suggestion to solve the problem?
Thanks in advance.
Joon
- Attachments
-
- cut problem.jpg (438.22 KiB) Viewed 5566 times
Re: Not accurate cutting problem.
Hi Jooh,
sorry for our late reply.
For your problem,there are still three checking you can do.
1.make sure the belt is tight enough;
2.find below link to improve the problem.
http://www.thunderlaser.com/troubleshoo ... -size.html
3.cut a 150×150 square,check if the diagonal is equal.
sorry for our late reply.
For your problem,there are still three checking you can do.
1.make sure the belt is tight enough;
2.find below link to improve the problem.
http://www.thunderlaser.com/troubleshoo ... -size.html
3.cut a 150×150 square,check if the diagonal is equal.
Re: Not accurate cutting problem.
Hey,
Please, let me know the vendor password.
Please, let me know the vendor password.
-
- Posts: 84
- Joined: Fri Jun 05, 2015 8:18 am