Hello there!
This is Joon.
I tried to move the cutting bed through z axis.
However, the bed cannot move upwards.
Now, the cutting bed is almost at the bottom of the machine.
And, I cannot make it upwards.
Please, let me know how to solve this problem.
Best,
Joon
Mars90_Z axis movement problem.
Moderators: baker, Thunder laser - Tom, Thunder Laser -Nolan
Forum rules
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
All members should make themselves familiar with the forum rules. Please ensure you read this section of the forum BEFORE posting.
This sub-forum is only for thunderlaser users ask for tech support from thunderlaser tech persons directly. The normal member should raise your questions in the General Discussion sub-forum. Before ask a new question, please read the "Previously Asked Questions"first to save your time.
-
- Posts: 84
- Joined: Fri Jun 05, 2015 8:18 am
Re: Mars90_Z axis movement problem.
Hi Joon,
please try to clean the detector area of auto focus,
it is dirty, and it can't detect any materials.
if it still can't work, please unplug it and try again.
any question, welcome to ask me again.
please try to clean the detector area of auto focus,
it is dirty, and it can't detect any materials.
if it still can't work, please unplug it and try again.
any question, welcome to ask me again.
Re: Mars90_Z axis movement problem.
Hey,
Thank you for your reply.
However, you may not understand the problem.
1. I do not use auto focus function.
I tried to move the bed manually.
But, the bed could not move upwards.
2. I had cleaned the machine periodically.
The sensor was not dirty at all.
3. I tried to turn off the machine and turn it on.
And then, tried to move the bed upwards but did not work.
4. The auto focus fuction also does not work the bed goes downwards only.
I hope I could get the solution from you!
Best,
Joon
Thank you for your reply.
However, you may not understand the problem.
1. I do not use auto focus function.
I tried to move the bed manually.
But, the bed could not move upwards.
2. I had cleaned the machine periodically.
The sensor was not dirty at all.
3. I tried to turn off the machine and turn it on.
And then, tried to move the bed upwards but did not work.
4. The auto focus fuction also does not work the bed goes downwards only.
I hope I could get the solution from you!
Best,
Joon
-
- Posts: 115
- Joined: Fri Jun 05, 2015 8:16 am
Re: Mars90_Z axis movement problem.
Hi Joon
This is Tom from thunder laser
Sorry reply so lately cause we are on holiday these days
Thank you for your carefully checking
And let me try to give you a solution
Yeah, i know you did not used the auto focus and also the sensor may not dirty at all
But it was activated even if its under has no any material
Please try to unplug its interface at the around of laser head
See the attached picture to know where to unplug
Thanks
This is Tom from thunder laser
Sorry reply so lately cause we are on holiday these days
Thank you for your carefully checking
And let me try to give you a solution
Yeah, i know you did not used the auto focus and also the sensor may not dirty at all
But it was activated even if its under has no any material
Please try to unplug its interface at the around of laser head
See the attached picture to know where to unplug
Thanks
- Attachments
-
- auto focus sensor.jpg (822.97 KiB) Viewed 3987 times