As I wrote before, even at 90% i get a 6ma reading.
The laser beam comes dead center out of the head, perfectly aligned.
The psu fan is working. When I press the test button after disconnecting the green connector. The laser shoots and i get a 6ma reading.
I will check the LEDs on the psu.
Search found 15 matches
- Fri Jul 15, 2016 10:10 am
- Forum: Thunder Laser Tech support
- Topic: Why the laser power went down--20160926
- Replies: 12
- Views: 17231
- Thu Jul 14, 2016 9:23 am
- Forum: Thunder Laser Tech support
- Topic: Why the laser power went down--20160926
- Replies: 12
- Views: 17231
Re: laser power went down
Ok, I found out that 6ma is not ok. Can someone tell me how to figure out if the PSU or the tube is defective?
- Wed Jul 13, 2016 2:13 pm
- Forum: Thunder Laser Tech support
- Topic: Why the laser power went down--20160926
- Replies: 12
- Views: 17231
Why the laser power went down--20160926
Today I cut 5mm acrylics. First everything was fine but after the third job it did not cut through anymore. Normally I cut 5mm acrylics with 10mm speed and 65% power. Now I have to cut twice with 5mm speed and 65% power. I cleaned all the mirrors and checked the laser alignment, but nothing helps. T...
- Wed Jul 13, 2016 2:08 pm
- Forum: Thunder Laser Tech support
- Topic: sending big files to laser---20160715
- Replies: 4
- Views: 10317
Re: sending big files to laser
I always send by ethernet. I solved it by using a usb stick now.
- Thu Jun 30, 2016 9:13 am
- Forum: Thunder Laser Tech support
- Topic: sending big files to laser---20160715
- Replies: 4
- Views: 10317
sending big files to laser---20160715
I am not able to engrave a 20x30cm picture. I always get errors like "Quit Processing" when I press Start in RDWorks or when I use the download function I get "File download failed". When I try to save as UFile it gets a file handle error. When I do not change the picture to a ne...